Tips for Using the Above-Ground Swimming Pool

There are many tips for using swimming pools. Are you ready for a water carnival with family and friends Prepare your family for buckets of outdoor fun and loads of wet wild memories. The above-ground swimming pool will thrill kids and adults alike!

Quickly remove the plastic smell of inflatable swimming pools.

  • Inflate the above-ground swimming pool and place it in a ventilated place to dry. This is the most convenient and practical method.
  • Fruit oranges are often found at home. First, wash them with detergent, then put the fresh orange peels in, and rinse them off for about 3 to 4 hours.

How to repair air leaks in inflatable swimming pools´╝č

  • Go to the river and put the swimming pool in the water to look for bubbles (if it is not by the river, you can use half of the water in a bucket, fill the pool with half air, and then immerse part by part in the bucket to find the bubbles). It can be pasted with thin plastic.
  • The inner wall of the pool is easy to find if there are bubbles. If the outer wall of the pool leaks, it will take a little effort. Go to the river and put the swimming pool in the water to find the bubbles. Use half of the water in a bucket and half of the air in the pool. , And then part by part invaded into the bucket to find the air bubbles, used shoe glue to make up, and pasted with thin plastic.

Extended information:

First, the inflatable pool cannot be directly used with some chemical disinfectants. You can clean the pool with soapy water, then dry the water with a rag and then put the inflatable pool in the shade to dry, but remember not to expose it to the sun, otherwise it will damage the pool The raw materials, or cause the glue to open at the adhesive, can not be left outside for a long time.

Second, the disinfection method is to deflate the swimming pool, soak it in hot water, and sterilize it by high temperature sterilization. The same disinfection and soaking time should not be too long. After the soaking, it should not be dried with a hair dryer. It should be natural. Let it dry or wipe off the moisture on it with a rag to avoid sticky glue or the growth of bacteria.

Third, when using an above-ground swimming pool, pay attention to the level of the ground and no sharp objects, otherwise the bottom of the swimming pool will be scratched. When using an air pump to inflate the pool, it should not be over-inflated. Excessive use will cause the pool to burst or deform.

Fourth, if you feel that the inner wall of the inflatable swimming pool is slippery and dirty, you can clean it with detergent first. Some oily dirt will be easily washed off. If it is a stubborn stain, you can directly sprinkle the washing powder on the dirty surface. Clean it with a soft brush, then rinse it with clean water and dry it.

Fifth, inject water to the required height of the pool. The water level should not exceed 2/3 of the height of the pool. If the water level is too high, the pool will deform and cause rupture.